Carvera Air Wired Probe (spare part)

About The Product:

• For Carvera Air™ only.

  Overview:

• The wired probe is one of the critical components of Carvera Air™ which is used for auto-probing and auto-leveling.

• There is already one included in the machine for you to use out of the box. But you can prepare a backup one as you wish.

• Installation:

• The probe is stored on the right side of the spindle by default, and the cable has been connected and is ready for immediate use.

•  The installation and removal method for the wired probe is the same as that for a standard milling bit. Learn more in the instruction manual.

  Note:

• Unlike the crash of other milling bits, the crash of a wired probe may cause serious damage to the probe. Please use the wired probe with caution.

• Always observe its traveling path, and stop the machine when finding any obstacles to protect the wired probe.

• What’s In the Box:

  - 1 * Wired Probe with 1/8" tail shaft installed
  - 1 * 1/8mm spare tail shaft
  - 1 * 4mm tail shaft
  - 1 * 6mm tail shaft
  - 1 * 1/4" tail shaft