MakerBot METHOD X SR-30 Support Filament (.45kg, 1lb)

Stratasys® SR-30

Dissolvable Support Material from Stratasys® for ABS, ASA, and high-temp materials.

Stratasys® SR-30 Special Features

SR-30 is a proprietary material developed by Stratasys to work seamlessly with ABS, ASA, and various other high-temp materials. Because of this focused development, using SR-30 with these typically more challenging materials can yield exceptional results not possible with PVA which is very difficult to use with ABS.

The SR-30 Soluble Support Filament for METHOD X has been designed and tested to work perfectly with MakerBot’s industrial grade printer, and is shipped in a vacuum-sealed metalised polyester bag to preserve its quality right up until opening. The filament comes wound around a Smart Spool™ that contains all the information that the printer needs, including material type, colour, and remaining amount via an embedded RFID chip that communicates directly to MakerBot Print.

Stratasys® SR-30 Specifications

Printer Compatibility: METHOD X

Material Type: Soluble Support Filament

Spool Type: Smart Spool™

Software Compatibility: MakerBot Print

Extruder Compatibility: Material Extruder 1XA, Support Extruder 2XA

Compatible Materials: MakerBot ABS, MakerBot ASA

Dimensional Accuracy: Finished part dimensional accuracy of ±0.2mm

Dimensions & Weight:Spool Diameter: 218mm

Spool Width: 42mm

Material Diameter: 1.75mm

Net Weight: 450g

Operating Environment: Store SR-30 in the included vacuum-sealed metalised polyester bag to avoid moisture absorption from air and long-term exposure to humidity, which can compromise material quality and performance. Make sure the built-in desiccant is in the spool to absorb any moisture exposure during the material loading process.